Code Alarm CA-120 Owner's Manual download pdf (Page 3)

Using Your Remote Control

Arming the Security System

To arm the system, exit the vehicle, close all doors, then press the LOCK button on the remote control. The

system will sound 2 times and the parking lights will flash 2 times, indicating the system is armed, has locked the

doors (if equipped and connected) and activated the starter disable feature. The status indicator (blue warning

light on the antenna) will blink steadily, once per second. To arm the system silently, press and hold the LOCK

button for 1 second. The parking lights will flash 2 times, indicating the system is armed, has locked the doors (if

equipped and connected) and activated the starter disable feature. The status indicator (blue warning light on the

antenna) will blink steadily, once per second.

Pre-arm Mode

If the system sounds 1 time and the parking lights flash only 1 time, this indicates that the vehicle’s interior light is

on or an entrance is left open. Check to see that all doors hood and trunk are closed properly. Once all entrances

are secured (and the interior light is off), this system will sound/flash again. The system is now fully armed. (If

the entrance is not secured within 4 minutes, the system will arm and ignore the unsecured entrance until it is

closed.)

Disarming the Security System

To disarm the system press the UNLOCK button. The system will sound and the parking lights will flash once,

and the doors will unlock (if equipped and connected). To disarm the system silently, press and hold the

UNLOCK button for 1 second. The parking lights will flash, indicating the system is disarmed and has unlocked

the doors (if equipped and connected).

Disabling/Enabling Confirmation Chirps

1. Turn the ignition key ON then OFF.

2. Within 10 seconds push and release the valet/override button 3 times.

3. The system will sound 2 times to disable confirmation chirps or 1 time to enable confirmation chirps.

Attempted Intrusion Identification

This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. If an

intrusion attempt occurred, the system will sound 4 times and the parking lights will flash 3 times when disarming

the system. Enter the vehicle an observe the dash mounted status LED to Identify which zone was triggered.

1. Shock Sensor - 1 flash, pause 1 flash, etc.

2. Hood or Trunk Pin switch - 2 flashes, pause 2 flashes, etc.

3. Door Entry - 3 flashes, pause 3 flashes, etc.

The intrusion warning indicators are stored in the system’s memory and will be erased when the ignition key is

turned on.

Two Stage Door Unlock (Optional)

If this feature is enabled on your system, pressing the UNLOCK button one time on the remote control will unlock

only the driver’s door. Press UNLOCK again to unlock the remaining doors.

Activating the Trunk Release Feature (Optional)

If this feature is enabled on your system, pressing and holding the TRUNK button on the remote control for 2

seconds will open the vehicle’s trunk or hatch.

*Throughout this manual, ‘press’ refers to pressing for less than 1 second; ‘press and hold’ refers to pressing for

more than 2 seconds.

1 2 3 4 5 6 7 8 ... 13 14

No comments

Code Alarm CA-120 Owner's Manual Page 3