Code-alarm CA-630 User Manual download pdf (Page 7)

Using Your Remote Starter (cont’d)

Entering the Vehicle While It is Running via Remote Start

1.Press the UNLOCK button on the remote control to unlock the

vehicle’s door(s) and turn off the alarm system (if it is not

already off).

2.Enter the vehicle. Do not press the brake pedal.

3.Insert the key into the ignition and turn to the ON position.

4.Press the brake pedal. The remote starter disengages and the

vehicle will operate normally.

Remote Start Safety Features

For safety and security reasons, the Code Alarm CA-630

will not

allow the vehicle to start if the following conditions are present:

• The vehicle hood is opened

• The system is in the Valet/Service mode

• The brake is pressed and held

For safety and security reasons, the CA-630 will terminate remote

start run time and shut the vehicle off if the following conditions are

present:

• The brake is pressed before the vehicle ignition is turned on

with the key

• The engine reaches 3 times its normal idle*

As a safety precaution, the vehicle will shut off if left unattended for 12

or 25 minutes, depending on the time preset by your installer.

Pre-Heating or Pre-Cooling the Interior of the Vehicle

Before exiting the vehicle, set the temperature controls to the desired

setting and operation. After the CA-630 starts the vehicle, the heater

or air-conditioning will activate and heat or cool the interior to your

setting.

Using the “Quick-stop” Feature

If you want to make a short stop and leave your vehicle running (to keep

the interior warm or cool, for instance), the quick stop feature allows

you to do this while keeping your vehicle secure and your keys with you.

To engage quick stop:

1.Stop the vehicle and place the transmission in PARK.

2.With your foot off the brake pedal, press the START button on

the remote control, the parking lights will turn on, indicating

that the vehicle is now running via remote start.

3.Remove the keys from the ignition and exit the vehicle. Press

the LOCK button on the remote control to arm the alarm

system if desired.

Note: Do not leave children or animals unattended in the vehicle

when using the quick stop feature.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Code-alarm CA-630 User Manual Page 7