Code Alarm CR3 Service Manual download pdf (Page 40)

Settings MIQ/CR3; DIQ/CR3

4 - 26

ba76032e01 01/2012

Canceling the cleaning A running cleaning cycle is canceled:

 Automatically

– If the sensor switches to the inactive condition during the cleaning

cycle

 Manually

– By pressing

– By switching on the maintenance condition

Each time the cleaning cycle is canceled, the relay opens immediately.

If the cleaning cycle is canceled automatically, the outputs linked to the

sensor are released immediately.

If the cleaning cycle is canceled manually, the sensor is in the

maintenance condition. The linked outputs are only released after the

maintenance condition was terminated manually.

The next cleaning cycle will be performed at the time set up.

Note

In case of a power failure, all relays open. The cleaning cycle is

canceled. The outputs linked with the sensor change to the non-active

condition (see section 4.8.2). As soon as the power is available, the

outputs are released again. The next cleaning cycle will be performed

at the time set up.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 65 66

No comments

Code Alarm CR3 Service Manual Page 40