Code Alarm F65 Troubleshooting Guide download pdf (Page 30)

1336 PLUS - 6.16 - September, 2001

4-2 Disassembly and Access Procedures

Tools

You need the following tools to disassemble and assemble the drive:

• Pliers

• #2 Phillips and a magnetic flat blade screwdriver

• 5/16 - inch or 8mm socket.

• Torque wrench, metered in lb-in. or N-m

Disassembly and Access

Procedures

Drive Enclosure Removal & Installation

ATTENTION:

Disconnect and lock out power from the drive

before disassembling the drive. Failure to disconnect power may

result in death or serious injury. Verify bus voltage by measuring

the voltage between +DC and -DC on Terminal Block TB1. Do

not attempt to service the drive until the bus voltage has

discharged to zero volts.

ATTENTION:

Wear a wrist type grounding strap when

servicing 1336 PLUS II Drives. Failure to protect drive

components against ESD may damage drive components. Refer

to Electrostatic Discharge Precautions at the beginning of this

chapter.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 38 39

No comments

Code Alarm F65 Troubleshooting Guide Page 30