Code Alarm Ca 1053 Installation Guide download pdf (Page 15)

Feature Bank 4 - Shock Sensor Adjustment

1. Enter Feature Bank 4

2. Press and release to select full trigger.

3. Use or to adjust the settings. The system will give short chirps upon

each press.

4. Press + for 2 seconds to lock in the change and advance to the lite

touch setting, the system will give 2 long chirps to confirm.

5. Use or to adjust the settings.

6. Press and release + to lock in the change, the system will exit

programming and give 1 long chirp to confirm. This step must be

completed to properly program the shock senor.

Chirp Delete - User Accessible

System ARM/DISARM chirps can be toggled ON or OFF without entering the

programming feature banks.

1. Turn the ignition ON then OFF.

2. Press and release the valet/programming button 3 times. The system

will respond with 1 chirp for ON or 2 chirps for OFF.

Dome Light Delay / Theater Dimming

The system can be programed to delay arming after the lock button is pressed (60

second max) for vehicles with a dome light delay or theater dimming feature. Once

programed the system will ‘learn’ the timing of the dome light delay and add 2

seconds before arming.

1. Close all doors with ignition off.

2. Using the transmitter press LOCK, UNLOCK, LOCK ,UNLOCK, LOCK ,

UNLOCK, LOCK. The LED will light solid to indicate the system has

entered DOME DELAY LEARN MODE.

3. Immediately OPEN then CLOSE the door WITHOUT disarming the

system. The system will then monitor the door trigger wire. Once the

dome light turns off, the system will then add 2 seconds and then exit

the learning mode.

4. The LED will begin to flash indicating the system has exited the

learning mode and is now armed.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

No comments

Code Alarm Ca 1053 Installation Guide Page 15