Code Alarm Ca 1053 Installation Guide download pdf (Page 13)

Manual Feature Programming - Feature Bank 2 - 4

1. Turn the ignition ON.

2. Press and hold the valet/override button.

3. Within 10 seconds the system will chirp (3) three times.

4. Use the valet/override button to advance through each option bank. For

feature programming advance to Feature Bank 2, 3, or 4 which is (4) four,

(5) five or (6) six chirps.

5. Use the transmitter button to scroll through the selections in each

feature bank, the system will chirp to match the feature number.

6. Press the transmitter button to change the desired feature. The LED will

flash indicating the changed feature.

Set Up & Programming

Transmitter Programming - Feature Bank 1

1. Turn the ignition ON.

2. Press and hold the valet/override button.

3. Within 10 seconds the system will chirp (3) three times.

4. Press 1 button of each transmitter you wish to program.

5. The system will respond with 1 chirp for each accepted transmitter.

6. Pressing the override button at anytime during programming will advance to

the next bank.

NOTE: The system will exit transmitter programming after 15 seconds of inactivity.

NOTE: This system has 1 button programming which programs all channels of the

system.

NOTE: The system will hold up to 4 transmitters in memory, programming a 5th

transmitter will erase the oldest transmitter in memory.

Defaulting All Features: Pressing the button anytime while in any of the

feature banks (except during shock sensor programming) will default all features

and return you to feature bank 2 - 4 chirps.

NOTE: The system will remain in feature programming mode as long as the

ignition is on, there is no time limit. To exit programming turn the IGNITION OFF.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Code Alarm Ca 1053 Installation Guide Page 13