Code Alarm CA-640 Instruction Manual download pdf (Page 21)

6. System Testing

1. Follow each instruction below.

2. Verify that the CA-640 operates as indicated under

each instruction.

3. Check the appropriate wire connections and/or fuses if the unit fails

to perform a specific function. Also check that any options

pertaining to the function are programmed properly.

Remote Start Operation

Press and hold START for 2 seconds.

1. Unit will chirp 4 times if tach is not yet learned or vehicle has not

been manually started if in Blind Crank Timing Mode.

2. Unit will chirp two (2) times if the neutral

safety input does not see

ground.

3. Unit checks to see if hood is open.

If so, parking lights flash two (2) times

and vehicle will not start.

4. Unit checks to see if brake is pressed.

If so, parking lights flash two (2) times

and vehicle will not start.

If the above conditions are not present:

1. Parking lights flash once.

2. Factory alarm (if equipped) is turned off.

3. Factory transponder systems (if equipped)

are interfaced (active output is activated).

4. Interior Sensor is disabled.

5. Vehicle ignition turns on.

6. Heater/AC are powered.

7. Vehicle starter begins to crank (heater/AC power shuts off while

vehicle starter is cranking).

8. Vehicle successfully starts.

9. Doors lock.

10.Vehicle will shut off if hood is opened, brake is pressed, or if engine

reaches 3 times its idle speed (Tach Sense Mode only). Vehicle will

also shut off if alarm is triggered.

11.Parking lights stay on for duration of run time.

12.Heater/AC is powered for duration of run time.

13.Vehicle runs for 12 or 25 minutes depending on setting of option.

* A two button start sequence (press LOCK, then press START within 2 seconds) can

be set in

Programming Option Bank 4/ Feature 7 (page 19).

CA-640.p65 10/20/03, 7:48 PM21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27

No comments

Code Alarm CA-640 Instruction Manual Page 21