Code Alarm CA-670 User Manual download pdf (Page 28)

Press DISARM:

1. Doors unlock.

2. Factory alarm (if equipped) is turned off.

3. Siren/horn sounds once/ parking lights flash once.

4. Courtesy lights turn on for 30 seconds, or until ARM is pressed or ignition is turned on.

5. Vehicle starter is enabled.

Press DISARM twice:

1. Passenger doors unlock if using 2-stage unlock.

Press FIND:

Siren/horn sounds 5 times.

Press and hold PANIC for 2 seconds:

Siren/horn sounds and lights flash for 30 seconds or until any remote control button is pressed.

Press and hold TRUNK:

Trunk or hatch opens, or other device activates.

If Ignition Lock option is set to On:

Doors lock when all doors are closed and key is turned to ON position.

If Ignition Unlock option is set to On:

Doors unlock when ignition is turned off.

9. System Testing Cont.

Remote Start Operation (if equpped)

Press then press START button twice within 2 seconds. (single press start is selectable)

1. Unit will flash 7 times if tach is not yet learned.

2. Unit will flash 4 times if the remote start saftey switch is not installed

If the above conditions are not present:

1. Parking lights flash once.

2. Factory alarm (if equipped) is turned off.

3. Factory VATS or PATS systems (if equipped)

are interfaced (active output is activated).

4. Interior Sensor is disabled.

5. Vehicle ignition turns on.

6. Heater/AC are powered.

7. Vehicle starter begins to crank (heater/AC power shuts off while vehicle starter is cranking).

8. Vehicle successfully starts.

9. Vehicle will shut off if hood is opened, brake is pressed, or if engine reaches 3 times its idle speed

(Tach Sense Mode only).

11.Parking lights stay on (or flash if selected) for duration of run time.

12.Heater/AC is powered for duration of run time.

1 2 ... 23 24 25 26 27 28 29 30

No comments

Code Alarm CA-670 User Manual Page 28