Code Alarm CA-670 User Manual download pdf (Page 9)

1. 4 PIN MAIN POWER HARNESS

Programming Tach Rate

The unit will not operate unless tach is programmed or tachless option is turned ON. If an attempt is made to

start the vehicle via the remote start without first programming tach, the unit will flash the parking lights 7 times

indicating tach has not been learned and stored. If the tach rate is not properly programmed to the specific vehicle,

the unit may not realize that the vehicle is running in certain instances reengage the starter motor.

The Remote Start Unit will learn the tach rate of most vehicle's single coil, multiple coil packs, or single injector.

To learn tach.

1. Turn the ignition key to the On position.

2. Press and release the valet/override button 3 times.

3. Immediately turn the ignition key Off.

4. Press and hold the valet/override button, then start the vehicle using the key.

5. When the unit senses the tach signal, the parking lights will begin to flash.

6. Allow the vehicle to settle to a norman idle speed.

7. Release the valet/program push-button switch. The parking lights will stay ON Solid indicating that the learned

tach signal is stored and the unit has exited tach learn mode.

NOTE: If the unit fails to learn tach rate due to an improper tachometer connection or a poor tach source, the

parking lights will not flash. To correct this situation, locate and connect the PURPLE/WHITE wire to the proper

tach signal, and then repeat the tach learn routine.

Tachless Mode

This unit has 2 types of tachless modes for your convenience:

1. Averaging - Averages the last 8 times the customer has cranked the vehicle and uses that value for the crank

output timing.

Note: When using this option you must crank the vehicle manually (1 Time) before the system will remote start.

2. Preset time - You can select the amount of time the unit cranks the vehicle. Refer to the Crank Average/Crank

Time.

Battery Power (RED)

Locate the vehicle’s battery wire(s) at the ignition switch.

Verification: These wires will register voltage in all positions of the ignition switch.

Connect the RED wire to the vehicle’s battery wire.

Note: Remove all 30 Amp fuses until all connections are made.

12 volts Ignition Input/Output (PINK)

Locate the vehicle’s Ignition wire at the ignition switch.

Verification: This wire registers voltage when the key is turned to the ON (or RUN) position. The voltage

does not drop out when the key is turned to the START (or CRANK) position.

Connect the PINK wire to the vehicle’s Ignition wire.

This wire is also used for Ignition 1 Output.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 29 30

No comments

Code Alarm CA-670 User Manual Page 9