Code Alarm ca5153 Installation Guide download pdf (Page 22)

AUX 1: Controls the VIOLET/BLACK AUX 1 output activation type and timing.

Push and Hold - Output is continuously active until transmitter button is

released.

Latched - Output stays active until button is pressed again.

Latched until IGN ON - Output stays active until the ignition is turned on.

Dome Light Output - Output used for illuminated entry and

not controlled

by the AUX 1 function of the transmitter.

Defrost Output Single Pulse - Single 1 second pulse after start

Defrost Output Latched 5 Minutes - 5 minute continuous output after

remote start.

Feature Bank

Remote Start Control

1 - RF Start Chirp: Turns remote start activation confirmation chirps ON or

OFF.

2 -

Run

Time: Controls the time

minutes that the vehicle will stay running

under control of the remote start until the system times out. The system may also

shut down at any time by use of the transmitter or system shutdowns.

Running Lights: Controls the WHITE parking light output wire during remote

start.

Steady - Parking lights constant during the remote start cycle.

Flashing - Parking lights flash at a slow pace during the remote start cycle.

4 - Tach Mode: Determines how the system monitors the engine running during

remote start.

Tach - Hard wired directly to the tach wire of the vehicle to monitor AC

voltage.

Tachless (Crank AverageNoltage) - Determines crank time by averaging the

last 8 times the vehicle was started with the key and then monitors the

change

voltage after remote start.

Hybrid (Crank Average

I No Voltage)- Determines crank time by averaging

the last 8 times the vehicle was started with the

key.

OBI

Port - Monitors the vehicle's tach rate through

interface module

connected to the

OBI

port.

ca5153/5153sst rev A

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 41 42

Comments to this Manuals

No comments

Code Alarm ca5153 Installation Guide Page 22

Comments to this Manuals

Related products and manuals for Car alarm Code Alarm ca5153