Code Alarm 2000 Operations Instructions download pdf (Page 11)

3 Other Indications

Mains Fail: The AC supply to the system has failed

Charger Fault: Fuse failure, or insufficient voltage present.

Battery Fault: Battery may be disconnected, or discharged (may

be due to prolonged power cuts, alarm

conditions, etc.) If indication does not clear

within 4 hours, call your engineer.

Line Fault: Telephone line to the communicator has failed.

Engineer Reset If this message appears after an alarm, phone

Needed: your security company who will

arrange for an engineer to check and reset

the system. See 3.1

24hr Zone Open A zone which is continuously live (eg PA, Fire,

Zone x 24Hr Tamper) has not been cleared after

silencing an alarm. This must be done before

attempting to set the system.

Tamper Open A wiring or similar fault exists on the zone

Zone x shown, which must be corrected before the

system can be set.

System Tamper A wiring or similar fault exists on the system,

CALL ENGINEER which must be corrected before the system can be

set.

Attention! Accompanied by a 'chime' tone, indicates that a

Zone x zone configured as a 'chime' zone has been

activated. Refer to section 2.6 for details.

NOTE: Except for 'CHIME,' the indication will clear from the display after the condition to

which it refers has cleared. To clear the 'Chime' indication, use the 'NO' key to scroll around

the 'System Ready' menu. Any indications remaining will show that the fault remains current.

3.1 Engineer Reset Needed

If this message is displayed on the keypad, the system is locked out, and cannot be reused

until checked and reset by an engineer from your alarm company.

Under certain circumstances, your Alarm Receiving Centre may permit you to reset the

system without an Engineer being present. If this is possible, the keypad will also include a

special "anticode" in the form

Engineer Reset

Needed: 12345 CCT

To use this code, contact the Alarm Receiving Centre by telephone, and quote the 5-digit

"anticode" which is displayed - stating that you have a Castle 2300 (2500 or 2700) Control -

and wait for further instructions. A code will be supplied, which should be entered whilst the

'Engineer Reset' message is displayed. The code will function for this one occasion only.

Note: Depending upon how the system is programmed, any 'Personal Attack' facilities within

the system may be live although the system is locked out for normal use.

Castle Care-Tech Ltd.

Page 10 Iss: 12

1 2 ... 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Code Alarm 2000 Operations Instructions Page 11

Comments to this Manuals

Related products and manuals for Car alarm Code Alarm 2000