Code Alarm 2000 Operations Instructions download pdf (Page 6)

2. Using the Alarm System

2.1 Setting the System

Before attempting to set the system, check that you have secured all the appropriate doors and

windows.

Check that the display shows 'System Ready.' If a fault message is shown (see section 5) take

the appropriate action, or use the 'NO' key to scroll till 'System Ready' shows.

Key in your full code (eg 1234).

NOTE the indications on the display, and the exact key entry sequence after entering your

code will vary according to the options programmed into the system, whether any area or

areas of the system are already set, etc. Do NOT therefore attempt to memorise a key sequence

to be entered without reference to the display. Note the options offered by the display, and

respond to them progressively until the exit tone commences.

The options which may be available are:

2.1.1 Setting with 'Select Areas' Option

If the facility to 'Select Areas' has been programmed , the display will show

Select Areas [ABCD]*

To change the areas being set, use the 'A,B,C,D' keys to change the status shown on the

display, then press 'YES'

* - The display will show the maximum areas which your code is authorised to set.

NOTE: Press the keys for the areas you wish to set; what is displayed in the window is what

you will SET when pressing 'YES'

If an area or area on the system are already set, the system will first present the option to

'Unset System?' - press 'NO' to move to 'Set System?' option.

Once the 'YES' key is pressed, the system may briefly show 'Please Wait' (see 2.4) and then

commence exit time as above, or move to next menu.

2.1.2 Silent Setting

If this facility has been programmed by your installing company, you have the option of

setting the system silently, for example to avoid disturbing sleeping members of the family.

Silent Set?

Press YES key to select this option

2.1.4 Omitting Zones

It is possible to omit individual zones at the time of setting, if this option has been

programmed by your installing company.

Omit Zones?

Press YES key if you wish to omit a zone, then key in the zone number eg 09, the display will

show

OMITTED: 09

This display will then change to

OMITTED : _ _

Lounge

Additional zone numbers may be entered in a similar way, and the identities will scroll

through in sequence. A zone may be removed from the 'omit' list by entering its number again.

Press YES to complete selection.

2000 Series Alarm System Operating Instructions

December 2000 Page 5

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Code Alarm 2000 Operations Instructions Page 6

Comments to this Manuals

Related products and manuals for Car alarm Code Alarm 2000