Code Alarm 2000 Operations Instructions download pdf (Page 8)

2.5 Unsetting the System

Enter via the authorised entry route, go to the keypad and enter the following commands (the

ENTRY TONE will continue to sound until the entry procedure is complete):

Enter User Code Key in your full code - eg 1234

Unset Areas [ABCD] YES key

System Ready Alarm system is UNSET.

If the alarm system is PART ARMED when you enter the building:

Enter User Code Key in your full code - eg 1234

Unset System? YES key

(Pressing the NO key will provide the option to

set additional areas.)

Unset Areas: [ABC ] Press 'YES' key, or key in areas you wish to

UNSET - ie what is displayed in the window is

what you will unset.

System Ready Alarm system is UNSET

If being forced by an intruder to unset the system, this can be done with a special

'DURESS' code. This will unset the system in exactly the same way, but will generate a silent

alarm signal to an Alarm Receiving Centre (if connected).

2.6 How to Silence an Alarm

If an alarm occurs during the day (due to wiring failure/ personal attack switch operated/ fire),

go to the nearest keypad. Do not panic, deliberately key in your code as requested:

Enter User

Code: - - - -

First Alarm [xx]

PA BUTTON

Deal with the cause of the alarm, then press YES to return the system to normal.

If the system alarms whilst the system is set, the alarm will automatically silence as the system

is unset (as above). The system is designed to automatically silence an alarm after a pre-set

time, and may be programmed to automatically reset itself at that point.

Should an alarm occur whilst the system is fully set, it may be silenced by ANY code valid for

the system. If the code is not valid for use with that area, the area will remain set, and able to

generate a further alarm. If the system is partially set, a code valid for the area in which the

alarm is generated must be used.

2.7 The Chime facility

If the system has been programmed to do so, certain detectors will cause a 'chime' to sound,

whilst the system (or that part of the system) is not set. The display will show

ATTENTION!

ZONE x

The indication will remain until cleared by using the 'NO' key.

This facility can be turned on and off by use of the 'C' key on any keypad, whilst the 'System

Ready' prompt is displayed. Two possibilities are available. With a lower case 'c' visible at

the right hand end of the lower line of the display (first press of 'C' key), the system will sound

a 'chime' only - but will NOT show on the display. If an upper case 'C' is displayed (second

press of 'C' key), the system will both chime and display the zone which has triggered. A third

press of the 'C' key will cancel the chime mode.

Note: the chime facility may have been programmed to give a single chime when the zone is

entered, or to chime continuously whilst the zone is 'open.'

2000 Series Alarm System Operating Instructions

December 2000 Page 7

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Code Alarm 2000 Operations Instructions Page 8

Comments to this Manuals

Related products and manuals for Car alarm Code Alarm 2000