Code Alarm CA680 User Manual download pdf (Page 20)

MM1 ITS Functionality

MM1 ITS Introduction

The MM1 may be used as a MM1 ITS (Interior Theft Sensor) and when doing so it is designed to honk the horn if

a light impact is detected or trigger the vehicle's factory alarm if a harder impact is detected.

Note: The vehicle MUST have a factory alarm that is triggered by opening the vehicle's door.

Option #10 must be changed in the MM1 programming bank for this to function as the MM1 ITS.

Optional Warn Away

The optional Warn-Away Trigger is active after the ignition key is turned off and the dome light shuts off after exiting

the vehicle. When a light impact is detected the system will briefly honk the vehicles horn. If at any time a door is

opened (dome light "on"), the Warn-Away Trigger will be bypassed until the ignition key is cycled "ON" and "OFF".

This feature prevents the Warn-Away chirps of the vehicle's horn when the customer/user enters the vehicle. The

Warn-Away Trigger will reactivate when the ignition key is cycled "ON" and "OFF" again.

Factory Alarm Trigger

The MM1 ITS Factory Alarm Trigger is active 5 minutes after the ignition is turned off and the factory alarm has been

set. When a heavy impact is detected the MM1 ITS will pulse the vehicle's door trigger wire to active the factory

alarm.

Valet Mode

Valet Mode deactivates both the optional Warn-Away and Factory Alarm Trigger. To turn Valet Mode ON, turn the

ignition key ON/OFF three times. To turn Valet Mode "OFF", turn the ignition key ON/OFF three times.

16 Pin Harness Connections

TAN - Factory Alarm Trigger: Connect this to a wire which triggers the vehicle's factory alarm system such as the

door ajar, hood or trunk wire.

PURPLE and GREEN/VIOLET - Door Inputs (+/-): Connect one of these wires to the vehicle's dome light wire.

RED - +12 Volt Input: Connect this wire to constant +12 volt source.

BLACK - Ground Input: Connect this wire to chassis ground.

PINK - Ignition Input: Connect this wire to +12 volt ignition source.

BROWN/BLACK - Warn Away Horn Output: Connect this wire to the vehicle's horn wire.

NOTES:

The MM1 ITS uses the PURPLE or GREEN/VIOLET (Door Input) to DISARM the optional Warn-Away feature. The

PURPLE or GREEN/VIOLET must sense all of the doors for the MM1 ITS to DISARM properly. It is recommended

to only use the Warn-Away feature with vehicle's that have an "ALL" door trigger output in the vehicle.

MM1 ITS ACTIVATION

1 2 ... 15 16 17 18 19 20 21 22

No comments

Code Alarm CA680 User Manual Page 20