Code Alarm SRT 5500 Specifications download pdf (Page 32)

December 2013

REQUEST FOR PROPOSALS FOR

PURCHASE AND DELIVERY OF HEAVY-DUTY BUSES

RFP SRTA-2014-01

TECHNICAL SPECIFICATIONS

PAGE-32



process. The entire LED assembly shall be specially coated to protect the light

from chemical and abrasion degradation.



i. Bottom lamp (back-up lamp) shall be LED Dialight, or approved equal, with

removable acrylic clear lens, replaceable 32 c.p. bulb number 1156.



j. Side turn signal lamps shall be located on each side of the coach at the forward

edge of the front wheel housing. The side signal lights shall be Dialight, or

approved equal, amber 18 Series lights. These lights shall be guarded for

protection. The light shall be visable from the rear and front of the coach as

well as outward. All electrical connections to the LED light shall be by wire

coming from the light housing and terminated with a Packard Weather Pak

connector, or approved equal. No interim connector shall be allowed on the body

of the light. The same type side signal lamp shall be located slightly above and

slightly forward of the rear wheel housing.



k. Intermediate side marker lights shall be Dialight LED Series 84, or approved

equal, one on each side of coach.



l. Wheelchair ramp/kneeling light shall be Dialight, or approved equal, LED 2

inch diameter located adjacent to the front entrance door.



m. License plate lamp shall be Dialight, or approved equal, LED recessed in right

lower quadrant of the engine compartment door.



n. Curb Dialight, or approved equal, LED lights, or approved equal, shall be

positioned in manufacturer's standard location above the front and rear doors in

such a manner as to illuminate the ground area in the immediate vicinity of the

stepwell. Dialight, or approved equal, LED lights shall be actuated when

entrance door, exit door, or both, are opened.



o. Directional lamps shall be equipped for simultaneous flashing for emergency

use. They shall be controlled by a switch located on the Driver’s side console, or

from a mometary foot operated push buton switch located on the floor on the left

side of the steering column with the side turn buttons. The SRTA will approve

the final configuartion of the floor switch layout at the pre-production meeting.



14.18 Interior Lighting



a. Front and rear stepwells shall be lighted by Dialight, or approved equal, LED

suitably mounted so that entire stepwell and a portion of the ground area

immediately outside the coach is illuminated.



b. An overhead interior LED lighting system, Dinex, or approved equal, shall

provide general illumination in the passenger compartment and shall be

controlled independent of the run switch. The system shall provide a

minimum of 15 foot-candles of illuminance on a one square foot plane at an

angle of 45 degrees, centered 33 inches above the floor and 24 inches in front

of the seat back at each seating position. The floor surface in the vestibule

shall be illuminated at a minimum of 4 foot-candles with the front door open and

a minimum of 2 foot-candles with the front door closed. Lighting intensity for all

cross seats, forward of the rear longitudinal seats, shall have a minimum

average of 15 foot candles, with a minimum of 12 foot candles at the seated

passenger reading plane. An effective level of lighting shall also be provided

for all other seated passengers. The

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 86 87

Comments to this Manuals

No comments

Code Alarm SRT 5500 Specifications Page 32

Comments to this Manuals

Related products and manuals for Car alarm Code Alarm SRT 5500