Code Alarm SRT 5500 Specifications download pdf (Page 35)

December 2013

REQUEST FOR PROPOSALS FOR

PURCHASE AND DELIVERY OF HEAVY-DUTY BUSES

RFP SRTA-2014-01

TECHNICAL SPECIFICATIONS

PAGE-35



e. The understructure shall incorporate minimum 3/16” steel floor material in the

area of the vestibule, the driver’s platform and the exit door area. The installation

shall be sufficiently rigid to prevent flexing, and to permit rigid mounting of a

farebox.



f. Understructure shall provide protected pathways for hydraulic lines, heater

piping, airlines and electrical cabling. PVC tubing shall be used as protective

conduit for wires and cables. Joints in lines, hoses, etc. shall be accessible for

repairing.



15.3 Construction: Exterior Panels



a. Body structure shall be modern, and aesthetically pleasing without protruding

fasteners. Visible exterior fasteners shall be kept to an absolute minimum.



b. Side panels below the window line shall be aluminum, etched, primed and

painted to the SRTA paint scheme. These side panels shall each be

replaceable by a mechanic without assistance. Welding, riveting, or adhesive

attachment is deemed unacceprable, although adhesive, as a secondary method

to control panel resonance will be permitted.



c. All side panels shall be essentially flat, without ripples and with minimal visible

joints.



d. Side panels shall be simple enough in shape to allow fabrication with no more

tooling than a shear brake and edge roller. Metal panels with compound curves,

fluting, curved indentations, etc. will not be permitted.



15.4 Construction: Hardware



Fasteners must be of non-corroding material or finished to prevent rust and corrosion.

Boron fasteners are not acceptable.



15.5 Insulation



a. Interior of body, including roof, must be well insulated against heat, cold and

noise.



b. Roof insulation shall polystyrene EPS insulation.



c. Sidewall insulation shall meet the same specifications as roof insulation. It shall

be installed in all sidewalls, window post areas, and areas over the front and rear

wheelhouses.



d. The insulation referred to above, or other additional insulation, shall provide

effective sound attenuation for the passenger.



e. There shall be Barymat BYUF-14C 1” foam insulation, or approved equal, in the

engine compartment to restrict, to the maximum practical extent, the entry of

fumes, odors and heat into the passenger area.



15.6 Flooring: Plywood

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 86 87

Comments to this Manuals

No comments

Code Alarm SRT 5500 Specifications Page 35

Comments to this Manuals

Related products and manuals for Car alarm Code Alarm SRT 5500